Progress with the cassette tray...here I've added the central spine, which will hopefully prevent bowing, and the cross piece for the layout end.
...and that's the tray pretty much done. I added three gluing blocks (from ply offcuts) to each side piece, also note the slight overlap at the top, to stop cassettes being pushed off the sides of the tray. I've left the rear open so cassettes can be slid, rather than lifted, in and out of use easily.
Still to do are the contacts between the transition and cassettes, plus finishing the remaining two cassettes, and I'll probably add a few corner braces to the tray.
After that, I will need a running session to spot and rectify any problems.
No comments:
Post a Comment